1. Select Board
Board Details
Reference Voltage: 3.3V
Total GPIO Pins: 0
Total Analog Pins: 0
Default I2C Bus: SCL: 0, SDA: 0
2. Select Companion Board (Optional)
You can skip this step if you're not using a companion board.
It's just a convenient way to prepopulate the Real-time clock model and SD Card's Chip Select pin option.
Companion Board Details
Real-time clock (RTC): None
SD Card CS Pin: None
Additional Components: None
3. Manual Configuration
SD Card Configuration
No SD card detected from companion board. Would you like to add an SD card? (REQUIRED)
Select SD Card CS Pin:
SD Card CS Pin:
Real-time clock (RTC) Configuration
Note: The RTC must be on the first (default) I2C bus.
No RTC detected from companion board.
RTC Type:
Status LED Configuration
4. I2C Bus Configuration
Default I2C Bus
SCL: , SDA:
Additional I2C Bus (Optional)
Select SCL Pin:
Select SDA Pin:
I2C Multiplexers (Optional)
5. Add Components
UART + other component categories are currently being implemented in offline mode (No ETA, but maybe reactive actions too!).
All Components
I2C Components
DS18x20 Components
Pin Components
Pixel Components
PWM Components
Servo Components
UART Components
6. Selected Components
No components selected yet.